Swage connection at both cable ends
Suzhou Lance Technology Co., Ltd.WWW.MR-RAIL.COM · MR.RAIL@FOXMAIL.COM
Products / MR-08Request quotation →
SWAGE SYSTEM
Swage Cable Railing Fittings for Wood Posts
MR-08 / MR-18 / MR-28
A traditional surface-mount Swage system with swivel bases for wood-post level and stair cable railing runs.
Material316 Stainless Steel
ApplicationWood posts · Level or stair runs
Cable1×19 or 7×7 stainless steel cable
Sizes1/8" · 5/32" · 3/16"
MODEL FAMILY
MR-081/8"MR-185/32"MR-283/16"
PRODUCT HIGHLIGHTS
Designed around the installation.
Swivel bases support level and angled runs
Wood screws included for wood-post installation
Compatible with 1×19 or 7×7 cable
CONNECTION TECHNOLOGY
Swage connection method
Both cable ends are inserted into Swage sections and permanently secured with a hydraulic crimping tool before final cable tensioning.
Technology comparison →INSTALLATION GUIDE
Reference installation steps for the model family.
The reference sequence applies within MR-08, MR-18, MR-28. Hole size, thread specification and tool size must follow the approved specification for the selected cable diameter and project configuration.
End functions and project configurations
An Ending secures a cable end without tension adjustment. A Tensioner provides the adjustment for tensioning the run. Ending + Tensioner and Tensioner + Tensioner are both possible configurations, selected for the actual installation and compatible components.
Swageless and Swage describe the cable connection, not the number of tensioning ends. Push-in locking does not replace final tensioning.
Standard model layouts are reference configurations, not a requirement to buy one fixed pair. MR.RAIL reviews standardized products, compatible component combinations and project-specific customization. Confirm the cable, post interfaces, adjustment access, exact components and quantities before ordering.
Mark aligned cable locations and fasten the surface-mount bases to the posts.
Measure and cut the matching cable after confirming fitting position.
Insert both cable ends fully into the Swage sections.
Confirm cable length, permanently crimp both Swage ends, then complete final tensioning.
Tools and preparation
Hydraulic crimping tool, cable cutter, drill or driver, wrench, pliers and suitable driver bit.
RELATED PRODUCTS
Continue building the system.
Model documentation and selection
Confirm the exact model, cable construction and diameter before ordering. The selected manual and approved project design govern installation; this page is not a structural or code-compliance certificate.
START YOUR CABLE RAILING HARDWARE PROJECT